Dell Latitude 5411 - Smartcard Reader; Removing the Smartcard Reader Board

Steps
1. Locate the coin-cell battery slot on your computer.
2. Adhere the coin-cell battery on to the slot.
3. Connect the coin-cell cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
SmartCard reader
Removing the smartcard reader board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the 2280 SATA SSD.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the inner frame.
About this task
The figure indicates the location of the smart card reader board and provides a visual representation of the removal procedure.
Disassembly and reassembly
41