Next steps
1. Install the DC-in.
2. Install the heatsink-UMA.
3. Install the LED board.
4. Install the inner frame.
5. Install the memory.
6. Install the WLAN card.
7. Install the WWAN card.
8. Install the 2280 SATA SSD.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Power button
Installing the power button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button with fingerprint and provides a visual representation of the installation procedure.
Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to the palmrest.
Next steps
1. Install the system board.
NOTE: System board can be installed with heatsink attached.
Disassembly and reassembly 59
To Next Page
Loading...
