Steps
1. Connect the display cable to the connector and close the latch.
2. Adhere the adhesive strip to secure the display cable connector.
3. Turn back and place the display panel over the display back cover.
4. Replace the two (M2.5x3) screws that secure the display panel to the display assembly.
Next steps
1. Install the display hinge caps.
2. Install the display bezel.
3. Install the display assembly.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
72
Disassembly and reassembly
To Next Page
Loading...
