Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palmrest on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Connect the display cable to the system board and adhere the tape to secure the display cable.
5. Place the display cable metal bracket on the display cable connector.
6. Replace the two (M2x3) screw to secure the display cable metal bracket to the system board.
7. Connect the touchscreen cable to the connector on the system board.
8. Replace the four (M2.5x5) screws that secure the display hinge to the chassis of the computer.
9. Route the WWAN cable and the WLAN cable through the retention clips provided.
Next steps
1. Install the WLAN card.
2. Install the WWAN card.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Disassembly and reassembly
81
To Next Page
Loading...
