5. Peel off the tape on the LCD connections [1] and open the connector [2] to disconnect the EDP cable [3] from the LCD.
6. Peel off the reflective tape [4] on the LCD panel and the touch connector [5] and disconnect the cable from the board [6].
Installing the LCD with bezel and the display back cover
assembly
1. Replace the EDP cable [1] on the LCD connector and close the actuator [2].
2. Secure the connector using a piece of tape [3] and adhere the reflective tape on the display panel [4] .
3. Connect the touch controller cable [5] and use insulation tape on the connector [6].
Removing and installing components
117
To Next Page
Loading...
