5. Lift the camera module away from the back cover [5] to remove it from the computer.
CAUTION: Do not touch the Camera Lens fused to the LCD with bezel assembly.
Installing the Camera
1. Install the camera module [1] on the back cover and install the two 'M2*3'. screws [2]
2. Connect the EDP cable to the camera module [3], stick a piece of insulation tape [4] on the EDP connectors.
3. Secure the camera module on the back cover using a piece of reflective tape [5].
4. Install the:
a. LCD with bezel assembly
b. Display assembly.
c. Hinge covers
Removing and installing components
129
To Next Page
Loading...
