Smart Card
Removing the Smart Card Reader
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Batteries
b. Bottom chassis cover
c. PCIe heatsink assembly
d. Battery bay
3. Remove the tape from the smart card reader connector[1] and disconnect it [2] from the USH board.
4. Remove the tape from the fingerprint reader connector [3] and disconnect it from the USH board [4].
5. Remove the two 'M2*3' screws [1] securing the USH board to the bottom base and turn it up side down [2].
Removing and installing components
135
To Next Page
Loading...
