Dell Latitude 5424 Rugged - Page 146

12. Remove the two 'M2*3' screws[1] on EDP bracket to remove the EDP bracket [2].
13. Disconnect the EDP cable [3] and disconnect the DC-In connector [4] from the system board.
14. Remove the two 'M2.5*5' screws and two 'M1.6*3.0' screws [1] from the USB Type-C bracket.
15. Remove the USB Type-C bracket [2] and the two cap screws in the rear I/O space [3] from the system board.
146
Removing and installing components