Removing and installing components
This section provides detailed information on how to remove or install the components from your computer.
Topics:
• Safety instructions
• Recommended tools
• Stylus
• SIM card
• Memory card
• Handle
• Latch Doors
• Battery
• Secondary SSD carrier
• Primary SSD carrier
• SSD
• HDD carrier
• Bottom Chassis Cover
• Keyboard
• WWAN card
• WLAN card
• Global Positioning System (GPS)
• Memory modules
• Coin-cell battery
• PCIe Heatsink Fan Assembly
• Primary SSD Rail
• Docking Port Assembly
• Heatsink Assembly
• Rear Input-Output Board
• Hinge Covers
• Display assembly
• LCD Bezel and Back Cover Assembly
• Microphone
• Camera
• Battery Bay
• Left I/O board
• Smart Card
• ExpressCard Reader
• Speaker
• System board
• Bottom Base Assembly
Safety instructions
Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless
otherwise noted, each procedure included in this document assumes that the following conditions exist:
● You have read the safety information that shipped with your computer.
● A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer.
For additional safety best practices information, see the Regulatory Compliance Homepage
3
64 Removing and installing components
To Next Page
Loading...
