• Loopback modes for diagnostics
• Advanced digital baseline wander correction
• Automatic MDI/MDIX crossover at all speeds of operation
• Automatic polarity correction
• MDC/MDIO management interface
• Flexible lters in PHY to reduce integrated LAN controller power
• Smart speed operation for automatic speed reduction on faulty cable plants
• PMA loopback capable (no echo cancel)
• 802.1as/1588 conformance
• Power Optimizer Support
• Intel Stable Image Platform Program (SIPP)
• iSCSI Boot
• Network proxy/ARP Ooad support
• Up to 32 programmable lters
• No support for Gb/s half-duplex operation
Security and Manageability
• Intel vPro support with appropriate Intel chipset components
Performance
• Jumbo Frames (up to 9 Kb)
• 802.1Q & 802.1p
• Receive Side Scaling (RSS)
• Two Queues (Tx & Rx)
Power
• Ultra Low Power at cable disconnect (<1 mW) enables platform support for connected standby
• Reduced power consumption during normal operation and power down modes
• Integrated Intel Auto Connect Battery Saver (ACBS)
• Single-pin LAN disable for easier BIOS implementation
• Fully integrated Switching Voltage Regulator (iSVR)
• Low Power LinkUp(LPLU)
MAC/PHY Interconnect
• PCIe-based interface for active state operation (S0 state)
• SMBus-based interface for host and management trac (Sx low power state)
Package/Design
• 48-pin package, 6x6mm with a 0.4 mm lead pitch and an Exposed Pad for ground
• Three congurable LED outputs
• Integrated MDI interface termination resistors to reduce BOM costs
62
Technology and components