Steps
1. Align the left hinge and replace the two (M3x7, T8) and (M3x5, T8) epoxy screws to secure the left hinge to the display
assembly.
2. Align the right hinge and replace the two (M3x7, T8) and (M3x5, T8) epoxy screws to secure the right hinge to the display
assembly.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the system board.
4. Install the rear I/O board.
5. Install the dock I/O board.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the Wi-Fi I/O board.
9. Install the heat-sink (UMA) or heat-sink (discrete).
10. Install the fan.
11. Install the base cover.
12. Install the keyboard.
13. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
14. Install the battery.
15. Follow the procedure in after working inside your computer.
Display cable
Removing the display cable
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
100
Removing and installing components
To Next Page
Loading...
