Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx T8 screwdriver
● 5.5 mm Socket wrench
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
M.2 2230 solid state drive M2x2
M2x4
M2x5
1
1
1
M.2 2280 solid state drive M2x4
M2x5
1
1
Handle M3.5x9 2
Keyboard M2.5x4 (rubberized
sealed)
M2.5x4 (standard)
4
6
4
2
Removing and installing components 11
To Next Page
Loading...
