Steps
1. Align the pins on the battery with the connector on the system.
NOTE: Ensure that the metal pin of the battery is aligned in place.
2. Place the battery into the battery bay until it clicks into place.
3. Slide the battery latch to the locked state.
4. Ensure that the battery release latch is in the locked state.
Next steps
1. Follow the procedure in after working inside your computer.
Primary solid state drive
Removing the primary M.2 2230 solid state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
About this task
The following images indicate the location of the primary solid state drive and provide a visual representation of the removal
procedure.
18
Removing and installing components
To Next Page
Loading...
