Steps
1. Adhere the coin-cell battery to the slot on the system chassis.
2. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
About this task
The following images indicate the location of the fan and provide a visual representation of the removal procedure.
Steps
1. Disconnect the fan cable from its connector on the system board.
2. Remove the three (M2.5x6.5) screws that secure the fan to the system chassis.
3. Lift the fan from the system chassis.
Removing and installing components
41
To Next Page
Loading...
