Steps
1. Place the LED board and replace the two (M2x3.5) screws that secure the LED board to the system chassis.
2. Connect the LED cable to the connector on the system board.
Adhere the LED flexible printed cable with kapton tapes to the connector.
Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Left I/O board
Removing the left I/O board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
About this task
The following images indicate the location of the left I/O board and provide a visual representation of the removal procedure.
54
Removing and installing components
To Next Page
Loading...
