Steps
1. Disconnect the speaker cable and peel the adhesive on the left I/O board.
2. Remove the two (M2x3.5) screws that secure the left I/O board to the system chassis.
3. Flip the left I/O board and disconnect the flexible printed cable to remove the left I/O board.
Installing the left I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left I/O board and provides a visual representation of the installation
procedure.
Removing and installing components
55
To Next Page
Loading...
