Installing the heat-sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat-sink and provides a visual representation of the installation procedure.
Steps
1. Align the heat-sink screw holes with the system board and place it on the system chassis.
2. Replace the three (M2x3.5) and four (M2x6) screws (in sequential order, 1->2->3->4->5->6->7) to secure the heat-sink to
the system board.
Next steps
1. Install the dock I/O board.
2. Install the WLAN.
3. Install the Wi-Fi I/O board.
4. Install the base cover.
5. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
6. Install the battery.
7. Follow the procedure in after working inside your computer.
Removing the heat-sink - for computers with discrete graphics
card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
62
Removing and installing components
To Next Page
Loading...
