Dell Latitude 5430 Rugged - Right Type-C Daughterboard; Removing the Right Type-C Daughterboard

Steps
1.
NOTE: Replace the new rubber sponges before replacing the memory module.
Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle.
3. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the system board.
2. Install the rear I/O board.
3. Install the dock I/O board.
4. Install the WWAN card.
5. Install the WLAN card.
6. Install the Wi-Fi I/O board.
7. Install the heat-sink (UMA) or heat-sink (discrete).
8. Install the fan.
9. Install the base cover.
10. Install the keyboard.
11. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
12. Install the battery.
13. Follow the procedure in after working inside your computer.
Right Type-C daughterboard
Removing the right Type-C daughterboard
Prerequisites
1. Follow the procedure in before working inside your computer.
Removing and installing components
77