13. Install the battery.
14. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the Wi-Fi I/O board.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the dock I/O board.
10. Remove the rear I/O board.
11. Remove the fan.
12. Remove the heat-sink (UMA) or heat-sink (discrete).
13. Remove the system board.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
89
To Next Page
Loading...
