Steps
1. Remove the two (M3x7, T8) epoxy screws and two (M2.5x5) screws that secure the hinge covers to the system chassis
and open the display.
2. Remove the two (M2.5x7) screws that secure the left/right hinge covers to the system chassis.
3. Remove the four (M3x7, T8) epoxy screws that secure the display assembly to the system chassis.
4. Lift and remove the display assembly from the system chassis.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components 91
To Next Page
Loading...
