Dell Latitude 5430 Rugged - Display Hinges; Removing the Display Hinges

About this task
The following image indicates the location of the camera and provides a visual representation of the installation procedure.
Steps
1. Place the camera module on the display panel and connect the eDP cable on the camera module.
2. Adhere the adhesive tape on the camera module.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the system board.
4. Install the rear I/O board.
5. Install the dock I/O board.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the Wi-Fi I/O board.
9. Install the heat-sink (UMA) or heat-sink (discrete).
10. Install the fan.
11. Install the base cover.
12. Install the keyboard.
13. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
14. Install the battery.
15. Follow the procedure in after working inside your computer.
Display hinges
Removing the display hinges
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
98
Removing and installing components