6. Remove the fan.
7. Remove the heat-sink (UMA) or heat-sink (discrete).
8. Remove the Wi-Fi I/O board.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O board.
12. Remove the rear I/O board.
13. Remove the system board.
14. Remove the display assembly.
15. Remove the display bezel.
About this task
The following images indicate the location of the display hinges and provide a visual representation of the removal procedure.
Steps
1. Remove the two (M3x7, T8) and (M3x5, T8) epoxy screws that secure the left hinge to the display assembly.
2. Remove the two (M3x7, T8) and (M3x5, T8) epoxy screws that secure the right hinge to the display assembly.
3. Lift to remove the left and right hinges from the display assembly.
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation
procedure.
Removing and installing components
99
To Next Page
Loading...
