Steps
1. Disconnect the battery cable from the system board, if it was not disconnected earlier.
2. Remove the three (M2x5) screws that secure the battery to the palm-rest assembly.
3. Lift the battery off the palm-rest assembly.
Installing the 4-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 4-cell battery and provides a visual representation of the installation procedure.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
32 Removing and installing components
To Next Page
Loading...
