Steps
1. Align and place the battery from the left side on the computer.
2. Replace the three (M2x5) screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Install the microSIM card.
3. Install the microSD card.
4. Follow the procedure in after working inside your computer.
Battery cable
Removing the battery cable
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the microSIM card.
4. Remove the base cover.
5. Remove the 3-cell battery or 4-cell battery.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
Removing and installing components
33
To Next Page
Loading...
