Steps
1. Align and place the keyboard on the keyboard bracket.
2. Replace the six (M2x2) screws to secure the keyboard to the keyboard bracket.
3. Flip the keyboard assembly.
4. Align and place the keyboard assembly on the palm-rest assembly.
5. Replace the seventeen (M2x2) screws to secure the keyboard assembly to the palm-rest assembly.
6. Connect the keyboard cable and keyboard backlight cable to the connector on the touchpad.
Next steps
1. Install the system board.
2. Install the assembly inner frame.
3. Install the memory module.
4. Install the WLAN card.
5. Install the WWAN card.
6. Install the M.2 2280 solid-state drive or M.2 2230 solid-state drive.
7. Install the 3-cell battery or 4-cell battery.
8. Install the base cover.
9. Install the microSIM card.
10. Install the microSD card.
11. Follow the procedure in after working inside your computer.
Removing and installing components
57
To Next Page
Loading...
