Steps
1. Disconnect the system fan cable from the connector on the system board.
2. Remove the two (M2x5) screws that secures the system fan and heat-sink assembly to the system board.
3. Loosen the four captive screws that secure the heat-sink assembly to the system board.
4. Lift the heat-sink assembly off the system board.
Installing the heat-sink assembly
Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
About this task
The following image indicates the location of the heat-sink assembly and provides a visual representation of the installation
procedure.
Ta bort och installera komponenter
41
To Next Page
Loading...
