7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the assembly inner frame.
About this task
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Steps
1. Open the latch and disconnect the smart card reader cable from the connector on the USH board.
2. Peel the smart card reader cable.
3. Remove the three (M2x2.5) screws that secure the smart card reader to the palm-rest assembly.
4. Lift the smart card reader off the palm-rest assembly.
Installing the smart card reader
Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
52
Ta bort och installera komponenter
To Next Page
Loading...
