5. Flip the keyboard assembly.
6. Remove the six (M2x2) screws that secure the keyboard to the keyboard bracket.
7. Remove the keyboard from the keyboard bracket.
Installing the keyboard assembly
Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
About this task
NOTE: The system board can be installed with the heat sink attached in order to simplify the procedure and preserve the
thermal bond between the system board and heat sink.
The following image indicates the location of the keyboard assembly and provides a visual representation of the installation
procedure.
56 Ta bort och installera komponenter
To Next Page
Loading...
