a. base cover
b. battery
c. WWAN card (optional)
d. hard drive assembly(optional)
e. chassis frame
3. To remove the system fan:
NOTE: This section is for UMA model only.
a. Disconnect the system fan cable from the connector on the system board [1].
b. Lift the system fan away from the computer [2].
Installing the system fan
Steps
1. Place the system fan into the slot on the computer.
2. Connect the system fan cable to the connector on the system board.
3. Install the:
a. chassis frame
b. WWAN card(optional)
c. hard drive assembly(optional)
d. battery
e. base cover
4. Follow the procedure in After working inside your computer.
Removing and installing components
33
To Next Page
Loading...
