Installing the SSD card
NOTE: The following procedure applies for SATA M.2 2280 and PCIe M.2 2280
1. Insert the SSD card into the connector on the system.
2. Replace the M2*3 screw that secures the SSD card to the system.
3. Place the Mylar shield over the SSD.
4. Install the :
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
Removing the SSD frame
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. SSD card
3. To remove the SSD frame:
a. Remove the M2x3 screw that secures the SSD frame to the system [1].
b. Lift the SSD frame from the system [2].
16
Removing and installing components
To Next Page
Loading...
