Installing the SSD frame
1. Place the SSD frame into the slot in the system.
2. Replace the M2x3 screw that secures the SSD frame to the system.
3. Install the:
a. SSD card
b. battery
c. base cover
4. Follow the procedure in After working inside your computer.
Hard drive
Removing hard drive
1. Follow the procedure in Before working inside your computer.
2. Remove the :
a. base cover
b. battery
3. To remove the hard drive:
a. Disconnect the hard drive cable from the connector on the system board [1].
b. Remove the four (M2 x 2.7) screws that secure the hard drive to the system [2].
Removing and installing components
17
To Next Page
Loading...
