Installing the WWAN card
1. Insert the WWAN card into the slot on the system.
2. Connect the WWAN antenna cables to the connectors on the WWAN card.
3. Replace the screw (M2X3) to secure the WWAN card to the computer.
4. Install the :
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the :
a. base cover
b. battery
3. To remove the memory module:
a. Pry the clips securing the memory module until the memory module pops-up [1].
b. Lift the memory module from the connector [2].
Removing and installing components
23
To Next Page
Loading...
