Power connector port
Removing the power connector port
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the power connector port:
a Remove the M2x3 screw that secures the adhesive tape of the display cable to the power connector bracket [1], and peel o
the adhesive tape.
b Disconnect the power connector cable from the connector on the system board [2].
c Remove the M2x3 screw to release the power connector bracket that secures the power connector port to your system [3].
d Remove the power connector bracket from the system [4].
e Pull the power connector port, and lift it from the system [5].
Installing power connector port
1 Align the power connector port along the grooves on the slot and push it down.
2 Place the metal bracket on the power connector port.
3 Replace the M2x3 screw that secures one end of the power connector bracket to the power connector port.
4 Connect the power connector cable to the connector on the system board.
Disassembly and reassembly
33
To Next Page
Loading...
