4 To remove the chassis frame:
a Remove the ve (M2x3) screws and eight (M2x5) screws that secure the chassis frame to the system [1].
b Lift the chassis frame from the system [2].
Installing the chassis frame
1 Place the chassis frame into the slot on the system.
NOTE
: Gently pull the keyboard cable and keyboard back light cables through the spacing in the chassis frame before
placing the chassis frame in the slot on the system.
2 Replace the ve (M2x3) screws and eight (M2x5) screws to secure the chassis frame to the system.
3 Connect the keyboard cable and the keyboard backlight cable to their connectors on the system.
NOTE
: There may be more than one cable to connect based on keyboard types.
4 Route the WLAN and WWAN (optional) cables through the routing channels.
5 Install the:
a WWAN card (optional)
b WLAN card
c SSD frame
d SSD card
e hard drive
f battery
g base cover
6 Follow the procedure in After working inside your system.
Disassembly and reassembly
35
To Next Page
Loading...
