4 To release the system board:
a Flip over the system and remove the two M2x3 screw that secure the display cable bracket in place [1].
b Lift the metal display cable bracket from the system [2].
c Disconnect the display cables from the connectors on the system board [3,4] and peel the adhesive tape securing the display
cable to the system.
d Disconnect the power connector port cable from the connector on the system board [5].
e Remove the two M2x5 screws that secure the Type-C USB bracket in place [6].
NOTE
: The metal bracket secures the DisplayPort over USB Type-C.
f Lift the metal bracket away from the system [7].
42
Disassembly and reassembly
To Next Page
Loading...
