Installing display assembly
1 Place the chassis on a plane surface.
2 Align the display assembly with the screw holders on the system and place it on the chassis.
3 Close the display.
4 Replace the two screws that secure the display assembly.
5 Flip over the system and replace two screws to secure the display assembly to the system.
6 Replace the single screw that secure the power connector bracket and the display cable to the system.
7 Connect the display cables to the connectors on the system board.
8 Place the metal bracket to secure the display cable.
9 Replace the (M2x3) screws to secure the metal bracket to the system.
10 Route the WLAN and WWAN cables through the routing channels.
11 Install the:
a hinge cover
b WWAN card (optional)
c WLAN card
d battery
e base cover
12 Follow the procedure in After working inside your computer.
Disassembly and reassembly
51
To Next Page
Loading...
