Solid state drive
Removing the SSD card
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the Solid State Drive (SSD) card:
a Peel the adhesive mylar shield that secures the SSD card [1].
NOTE: Need to be removed carefully in order to be reused on the replacement SSD.
b Remove the M2x3 screw that secures the SSD to the system [2].
c Slide and lift the SSD from the system [3].
NOTE: This applies only to the SATA M.2 2280 version of the SSD
Installing the SSD card
1 Insert the SSD card into the connector on the system.
2 Replace the M2x3 screw that secures the SSD card to the system.
16
Disassembly and reassembly
To Next Page
Loading...
