Installing the memory module
1 Insert the memory module into the memory connector at a 30 degree angle until the contacts are fully seated into the slot. Then, press
the module until the clips secure the memory module.
2 Install the :
a battery
b base cover
3 Follow the procedure in After working inside your computer.
WLAN card
Removing WLAN card
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the WLAN card:
a Remove the (M2x3) screw that secures the WLAN card bracket to the system [1].
b Remove the WLAN card bracket that secures the WLAN antenna cables [2].
c Disconnect the WLAN antenna cables from the connectors on the WLAN card [3].
d Lift the WLAN card away the connector as shown in the gure [4].
Disassembly and reassembly
21
To Next Page
Loading...
