Installing display assembly
1 Place the chassis on a plane surface.
2 Align the display assembly with the screw holders on the system and place it on the chassis.
3 Close the display.
4 Replace the two screws that secure the display assembly.
5 Replace the screws that secure the power connector bracket and the display cable to the system.
6 Flip over the system and replace two screws to secure the display assembly to the system.
7 Replace the single screw that secure the power connector bracket and the display cable to the system.
8 Connect the display cable to the connector on the system board.
9 Place the metal bracket to secure the display cable.
10 Replace the (M2x3) screws to secure the metal bracket to the system.
11 Route the WLAN and WWAN cables through the routing channels.
12 Install the:
a hinge cover
b WWAN card (optional)
c WLAN card
d battery
e base cover
13 Follow the procedure in After working inside your computer.
Disassembly and reassembly
51
To Next Page
Loading...
