Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to chassis of your computer.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the inner frame.
4. Install the WWAN card.
5. Install the WLAN card.
6. Install the HDD.
7. Install the solid state drive.
8. Install the battery.
9. Install the base cover.
Disassembly and reassembly
99
To Next Page
Loading...
