Dell Latitude 5590 - Removing and Installing Components

Removing and installing components
This section provides detailed information on how to remove or install the components from your computer.
Removing and installing components
This section provides detailed information on how to remove or install the components from your computer.
Recommended tools
The procedures in this document require the following tools:
• Phillips #0 screwdriver
• Phillips #1 screwdriver
• Plastic scribe
NOTE
: The #0 screw driver is for screws 0-1 and the #1 screw driver is for screws 2-4
Screw size list
Table 1.
Component M2.0x3.0 M2.5x3.5 M2.5x5.0 M2.0x2.5
M2x3.0
(OD4.5)
M2x5
Base cover 8
Battery 1
Soild State Drive 1
SSD frame 1
WLAN card 1
Keyboard 6
Heat sink 4
System board 3 3
Power connector 1
Chassis frame 5 2
Smart card reader 2
Touchpad panel 2
LED board 1
Hinge cap 2
Display assembly 6
2
Removing and installing components 11