Installing the battery
NOTE
: 68Whr battery can use either a M.2 or 7mm SATA drive.
1 Insert the battery into the slot on the laptop.
NOTE
: Wrap the battery cable below the battery routing channel to enable proper connection to the connector.
2 Connect the battery cable to the connector on the system board.
3 Tighten the M2x5 screw to secure the battery to the laptop.
4 Install the base cover.
5 Follow the procedure in After working inside your computer.
Solid State Drive — optional
Removing the M.2 Solid State Drive - SSD
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the SSD:
a Remove the M2.0x3.0 screw (1) that secures the SSD bracket to the laptop and lift the SSD bracket that secures the SSD card
to the system board [1],[2] .
Removing and installing components
15
To Next Page
Loading...
