a. Push to disconnect the speaker cable from the connector on the system board [1].
NOTE: Ensure to unroute the speaker cable from the routing clip.
NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in
breakage.
b. Un-route the speaker cable from the routing clips [2].
c. Remove the tape that secures the speaker cables to the touchpad board [3].
5. To remove the speaker module:
a. Remove the M2.0x3.0 screws (4) that secure the speaker module to the computer [1].
b. Remove the M2.0x3.0 screws that secure the speaker module to the computer [1].
NOTE: Refer the speaker screw list
c. Lift the speaker module from the computer [2].
NOTE: Ensure to un-route the speaker cable from the routing clips.
Disassembly and reassembly 17
To Next Page
Loading...
