11. Route the speaker cable along the tab [1] beside the LED daughterboard and connect it to the system board [2].
12. Route the LED daughterboard FFC cable [3] over the rubber routing channel on the coin cell and connect it to the system
board [4].
1. Install the display assembly
2. Install the power adapter port.
3. Install the heatsink-fan assembly.
4. Install the WLAN card.
5. Install the SSD.
6. Install the memory.
7. Install the battery.
8. Install the base cover.
9. Follow the procedure after working inside your computer.
Removing and installing components
75
To Next Page
Loading...
