7. Remove the heatsink-fan assembly.
8. Remove the power adapter port.
9. Remove the speaker.
10. Remove the display assembly.
11. Remove the system board.
1. Remove the two (M2x2.5) screws, that secure the power-button board to the palmrest assembly [1].
2. Remove the power-button board from its slot, in the palmrest assembly [2].
NOTE: Power-button board with Finger Print Reader (FPR), has a cable that disconnects from the system board.
Figure 3. Power-button board without FPR
78
Removing and installing components
To Next Page
Loading...
