NOTE: Backlit keyboards have an extra backlight cable to be connected to the touchpad module.
1. Install the power button.
2. Install the coin cell.
3. Install the system board.
4. Install the display assembly
5. Install the power adapter port.
6. Install the heatsink-fan assembly.
7. Install the WLAN card.
8. Install the SSD.
9. Install the memory.
10. Install the battery.
11. Install the base cover.
12. Follow the procedure after working inside your computer.
Palmrest
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the memory.
5. Remove the SSD.
6. Remove the WLAN card.
7. Remove the heatsink-fan assembly.
Removing and installing components
85
To Next Page
Loading...
