About this task
The following images indicate the location of the M.2 solid-state drive and provide a visual representation of the removal
procedure.
Steps
1. Remove the single (M2x2.5) screw securing the M.2 solid-state drive shield in place.
2. Remove the M.2 solid-state drive shield from the computer.
NOTE:
If the thermal pad located under the M.2 SSD gets detached from the system board, re-adhere it to the system
board.
3. Slide the M.2 solid-state drive out the computer.
Installing the M.2 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
22
Removing and installing components
To Next Page
Loading...
