About this task
The following image indicates the location of the M.2 solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Align the notch on the M.2 solid-state drive with the tab on the M.2 solid-state drive slot on the system board.
2. Slide the M.2 solid-state drive into the M.2 solid-state drive slot on the system board..
3. Align and place the M.2 solid-state drive shielding cover on the M.2 solid-state drive.
NOTE: Ensure the shielding cover is placed on the guiding clips of the system board.
4. Replace the single (M2x2.5) that secures the M.2 solid-state drive shield to the system board.
Next steps
1. Install the display assembly.
2. Install the SIM tray.
3. Follow the procedure in After working inside your computer.
Removing and installing components
23
To Next Page
Loading...
