Steps
1. Align the screw holes on the system board with the screw holes on the frame.
2. Replace the two (M2x2) screws that secure the system board to the frame.
3. Connect the volume button FPC, USH FFC, audio port FPC, rear-facing camera FPC, and the power button daughter board
FPC to the system board
4. Connect the Darwin antennas and the P-sensor cable to the system board.
5. Place the Darwin antenna brackets on the Darwin antenna connector.
6. Replace the two (M1.6x2.5) screws that secure the Darwin cable brackets to the system board.
Next steps
1. Install the heat sink.
2. Install the kickstand hinges.
3. Install the kickstand.
4. Install the Microphone.
5. Install the solid-state drive.
6. Install the right system fan.
7. Install the left system fan.
8. Install the WWAN card.
9. Install the display assembly.
10. Install the SIM tray.
11. Follow the procedure in After working inside your computer.
Removing and installing components
63
To Next Page
Loading...
