Steps
1. Align and place the smart card reader on the frame.
2. Replace the three (M2x2) screws that secure the smart card reader to the frame.
3. Connect the smart card reader FPC to the connector on the USH board and close the latch.
4. Place the smart card reader support brackets on the smart card reader.
5. Replace the three (M2x2) screws that secure the smart card reader support bracket to the frame.
Next steps
1. Install the battery.
2. Install the system board.
3. Install the heat sink.
4. Install the kickstand hinges.
5. Install the kickstand.
6. Install the Microphone.
7. Install the solid-state drive.
8. Install the right system fan.
9. Install the left system fan.
10. Install the WWAN card.
11. Install the display assembly.
66
Removing and installing components
To Next Page
Loading...
